[source] ramips: DTS: VoCore2 improvements/fixes

[LEDE Commits]

mkresin pushed a commit to source.git, branch lede-17.01:
https://git.lede-project.org/ece85e2e49e021cea0455e19182c67854bbb9eb8

commit ece85e2e49e021cea0455e19182c67854bbb9eb8
Author: Paul Wassi <p.wassi at gmx.at>
AuthorDate: Sat Jul 22 11:15:55 2017 +0200

    ramips: DTS: VoCore2 improvements/fixes
    
    The VoCore2 features 128MB of RAM, therefore set
    memory in DTS to 128*1024*1024 = 0x8000000
    The board's LED is connected to GND, set it to
    ACTIVE_HIGH here.
    Make serial console working again on kernel 4.9 by
    change of pinmux configuration.
    
    Signed-off-by: Paul Wassi <p.wassi at gmx.at>
---
 target/linux/ramips/dts/VOCORE2.dts | 25 +++----------------------
 1 file changed, 3 insertions(+), 22 deletions(-)

diff --git a/target/linux/ramips/dts/VOCORE2.dts b/target/linux/ramips/dts/VOCORE2.dts
index 297cd1b..9173951 100644
--- a/target/linux/ramips/dts/VOCORE2.dts
+++ b/target/linux/ramips/dts/VOCORE2.dts
@@ -15,7 +15,7 @@
 
 	memory at 0 {
 		device_type = "memory";
-		reg = <0x0 0x4000000>;
+		reg = <0x0 0x8000000>;
 	};
 
 	gpio-leds {
@@ -23,7 +23,7 @@
 
 		status {
 			label = "vocore2:fuchsia:status";
-			gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
+			gpios = <&gpio1 12 GPIO_ACTIVE_HIGH>;
 		};
 	};
 };
@@ -31,28 +31,9 @@
 &pinctrl {
 	state_default: pinctrl0 {
 		gpio {
-			ralink,group = "refclk", "gpio";
+			ralink,group = "wled_an", "perst", "wdt";
 			ralink,function = "gpio";
 		};
-
-		agpio {
-			ralink,group = "agpio";
-			ralink,function = "uart2";
-		};
-	};
-
-	uart1_pins: uart1 {
-		uart1 {
-			ralink,group = "uart1";
-			ralink,function = "uart1";
-		};
-	};
-
-	uart2_pins: uart2 {
-		uart2 {
-			ralink,group = "spis";
-			ralink,function = "pwm";
-		};
 	};
 };