mesh SAE auth on low spec devices

[Lukas Göstl]

Hi all,

I successfully built up a secure Mesh Network with 8 Nodes, however the peering/authentication takes sometimes about 10 minutes or fails completely.

I found out that during authentication time my CPU was overloaded. So I edited the Source of the mesh_mpm to authenticate to only one Peer at a time and ignore other peer notifications.

It works for me, but is this the right way to do it?

Patch is attached.

Thanks,
Lukas

[Buildings under Control Symposium from October 20-21, 2015 - Register now!]<https://www.loytec.com/bucs>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.shmoo.com/pipermail/hostap/attachments/20150811/8d7f9cc0/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: single_peering.patch
Type: application/octet-stream
Size: 3176 bytes
Desc: single_peering.patch
URL: <http://lists.shmoo.com/pipermail/hostap/attachments/20150811/8d7f9cc0/attachment-0001.obj>