[PATCH 6/6] P2P: update listen and operating channel from p2p dbus

Jean-Michel Bachot Jean-Michelx.Bachot
Mon Jun 27 02:24:54 PDT 2011


Le 25/06/2011 11:11, Jouni Malinen a ?crit :
> On Thu, Jun 09, 2011 at 04:41:05PM +0000, Sane, Jayant wrote:
>> Some P2PDevice properties were not updated in p2p->cfg structure :
>> reg_class ,channel , op_reg_class and op_channel.
>> Hence,  Update p2p->cfg parameters through p2p core calls in wpas_p2p_update_config
>> function.
> Thanks, applied. However, I would like to point out that these
> configuration parameters are not really meant for normal use and it
> would be interesting to hear what kind of use case you are planning for
> them.
  Parameters setting allows just to control manually the setting of the 
listen channel and
the operating channel.
>   In general, I would recommend leaving these unconfigured and allow
> wpa_supplicant to take care of selecting the Listen channel and
> operating channel based on network conditions. If a specific operating
> channel is desired, that should be configured as an argument to group
> formation/addition rather than with this global parameter.
I agree.



More information about the Hostap mailing list