Leap

[Matthew Cross]

Kernel is 14-1656.  I upgraded the drivers on my own
to support leap.  I have the 2.4 firmware, and dmesg
shows no errors.
I get the same errors with scan_ssid=0.  I tried using
wext but it always fails, says it doesn't recognize
it.


--- Jouni Malinen <jkmaline at cc.hut.fi> wrote:

> On Fri, Feb 03, 2006 at 02:54:32PM -0500, Matthew
> Cross wrote:
> 
> > I have an ipw2200BG, drivers are 1.0.10 which is
> > reported to support leap, and ieee is 1.1.9
> anything
> > else that might help let me know and I'll check
> and
> > post.
> 
> Which kernel version are you using?
> 
> > My wpa_supplicant.conf is:
> > network={
> >         ssid="ten-179-0"
> >         scan_ssid=1
> 
> Please note that ipw2200 driver is unlikely to
> support scan_ssid=1
> option. If you are using a hidden SSID, ap_scan=2
> mode would be more
> likely to work.
> 
> > When I try to run:
> > wpa_supplicant -ieth1 -Dipw
> -c/etc/wpa_supplicant.conf
> 
> Can you please test with with -Dwext? ipw2200 is
> moving to use Linux
> wireless extensions and I don't know whether things
> like authentication
> algorithm configuration for Network EAP was added
> for the old -Dipw
> ioctls.
> 
> > When I run
> > wpa_supplicant -eth1 -Dndiswrapper
> > -c/etc/wpa_supplicant.conf I get the same get the
> > trying to associate and time out, but without the
> > complaint of the ioctl thing.
> 
> This is invalid configuration if eth1 is using
> ipw2200 driver.
> ndiswrapper uses its own private ioctls and ipw2200
> does not use these.
> 
> -- 
> Jouni Malinen                                       
>     PGP id EFC895FA
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
> 



	

	
		
__________________________________________________________ 
Find your next car at http://autos.yahoo.ca