Packet Loss

[Andrew Hodel]

No problem with connectors/cables, it is doing this on 40+ nodes.

This is a mesh network so ad-hoc is my only option.  AFAIK it does the
same in master managed.

I am also getting tcp connection resets, for example ssh will only
stay open for 5-10 seconds.

When I set frag 500 rts 250 rate 11M fixed where it was frag 256 rts
64 rate auto the results are better.  However, I am still getting tct
connection resets.


Andrew

On 7/28/05, Andrew Hodel <andrewhodel at gmail.com> wrote:
> No problem with connectors/cables, it is doing this on 40+ nodes.
> 
> This is a mesh network so ad-hoc is my only option.  AFAIK it does the
> same in master managed.
> 
> I am also getting tcp connection resets, for example ssh will only
> stay open for 5-10 seconds.
> 
> 
> 
> Andrew
> 
> On 7/28/05, ben.awol at webhost1.awol.net.au <ben.awol at webhost1.awol.net.au> wrote:
> > 30-40% only in adhoc ? , tried master/managed?
> >
> > any problem with the connectios/cabling?
> >
> >
> >
> > On Thu, Jul 28, 2005 at 09:35:37AM -0500, Andrew Hodel wrote:
> > > Using prism cards in ad-hoc mode, firmware 1.7.4 I am having major packet loss.
> > >
> > > 2 outdoor antennas (6dBi omni) that are 200ft from each other have a
> > > 30-40% packet loss using ping -f (*nix).
> > >
> > > If I take 2 wrt54g's on the same channel at the same locations I get
> > > 0-1% packet loss with ping -f?
> > >
> > > Any ideas?
> > >
> > >
> > >
> > > Regards,
> > > Andrew Hodel
> > > _______________________________________________
> > > HostAP mailing list
> > > HostAP at shmoo.com
> > > http://lists.shmoo.com/mailman/listinfo/hostap
> >
>