[PATCH v3] ARM: imx: Add Support for Webasto ccbv2

[Sascha Hauer]

On Wed, Oct 14, 2020 at 08:18:58AM +0200, Rouven Czerwinski wrote:
> Add support for the Webasto Common Communication Board Version 2. The
> device tree included with barebox can eventually be replaced with the
> required barebox changes when the ccbv2 device tree is upstream.
> 
> Signed-off-by: Rouven Czerwinski <r.czerwinski at pengutronix.de>
> ---
> v2 → v3:
> - Added SPDX license identifier to the flash header
> - Combined initcalls and moved to board driver
> - Removed unnecessary CONFIG_DEBUG_LL check
> - Added board to defconfig and tested defconfig compilation
> 
> v1 → v2:
> This should address all comments from the previous patch series,
> thanks to Sascha, Ahmad and Roland for the review.
> - Barebox should now correctly chainload if early OP-TEE was loaded
> - DTS files have been split up
> - Uses the iomux file for i.MX6UL to setup the UART instead of magic
>   values
> - Application of the overlay checks the board compatible before
>   application of the overlay.

Applied, thanks

Sascha



-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |