[PATCH 1/1 v2] ARM: i.MX31: Add support for mx31moboard board

[Sascha Hauer]

On Fri, Feb 28, 2014 at 08:35:11PM +0400, Alexander Shiyan wrote:
> Пятница, 28 февраля 2014, 17:27 +01:00 от Philippe Rétornaz <philippe.retornaz at epfl.ch>:
> > The mx31moboard is used on the marXbot, Eyebot and Footbot robot.
> ...
> > diff --git a/arch/arm/mach-imx/Kconfig b/arch/arm/mach-imx/Kconfig
> > index 79ea694..b7e7533 100644
> > --- a/arch/arm/mach-imx/Kconfig
> > +++ b/arch/arm/mach-imx/Kconfig
> > @@ -14,6 +14,7 @@ config ARCH_TEXT_BASE
> >  	default 0xa7f00000 if MACH_PCA100
> >  	default 0xa0000000 if MACH_PCM038
> >  	default 0x87f00000 if MACH_PCM037
> > +	default 0x87f00000 if MACH_MX31MOBOARD
> >  	default 0x87f00000 if MACH_PCM043
> >  	default 0x08f80000 if MACH_SCB9328
> >  	default 0xa7e00000 if MACH_NESO
> > @@ -363,6 +364,16 @@ config MACH_PCM037
> >  	  Say Y here if you are using Phytec's phyCORE-i.MX31 (pcm037) equipped
> >  	  with a Freescale i.MX31 Processor
> 
> Just a hint for Sascha. Can we replace all of these with
> default 0xXX if ARCH_IMXxx?

No, because the location is at the end of SDRAM. With the SoC we only
know the start of SDRAM, but not the size which is board specific.

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |