[PATCH] Makefile: add target to produce a SPL compatible uImage

[Jan Lübbe]

On Thu, 2012-09-20 at 21:13 +0200, Jan Luebbe wrote:
> This is mostly useful during the initial port of barebox to a new
> board which is supported by u-boot. It also allows starting barebox
> from a SRAM-based u-boot SPL.
> 
> A different load address can be set like this:
> make barebox.uimage UIMAGE_BASE=0x80000000
> 
> Also add barebox.ubl to CLEAN_FILES.
> 
> Signed-off-by: Jan Luebbe <jlu at pengutronix.de>
> ---
> I've carried this patch for some time and adjusted it to support
> PBL (compressed image), but have not had an opportunity to verify
> it again.
> 
> Teresa, if you have some time to try it out, that would be very
> much appreciated. :)

Sascha: As Teresa has tested this, could you apply it?

Regards,
Jan
-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |