[PATCH 4/7] at91/boards: switch to software ecc as in linux kernel

[Jean-Christophe PLAGNIOL-VILLARD]

On 11:18 Mon 19 Sep     , Sascha Hauer wrote:
> On Fri, Sep 16, 2011 at 02:23:45PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote:
> > Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
> > ---
> >  arch/arm/boards/at91sam9260ek/init.c     |    2 +-
> >  arch/arm/boards/at91sam9263ek/init.c     |    2 +-
> >  arch/arm/boards/pm9263/init.c            |    2 +-
> >  arch/arm/mach-at91/at91sam9g45_devices.c |    2 +-
> >  4 files changed, 4 insertions(+), 4 deletions(-)
> > 
> > diff --git a/arch/arm/boards/at91sam9260ek/init.c b/arch/arm/boards/at91sam9260ek/init.c
> > index 861e898..e4b98bf 100644
> > --- a/arch/arm/boards/at91sam9260ek/init.c
> > +++ b/arch/arm/boards/at91sam9260ek/init.c
> > @@ -64,7 +64,7 @@ static struct atmel_nand_data nand_pdata = {
> >  	.cle		= 22,
> >  /*	.det_pin	= ... not connected */
> >  	.ecc_base	= (void __iomem *)(AT91_BASE_SYS + AT91_ECC),
> > -	.ecc_mode	= NAND_ECC_HW,
> > +	.ecc_mode	= NAND_ECC_SOFT,
> 
> What does the Atmel nand bootloader expect (I assume it's possible to
> boot from NAND, right?). Is it software or hardware ecc?
don't care the ecc is not manage by the rom code

Best Regards,
J.