booting pandaboard rev A2 problems

[Sascha Hauer]

On Fri, Jun 17, 2011 at 09:26:46PM +0200, Belisko Marek wrote:
> Hi,
> 
> I'm trying to boot barebox on Panda rev. A2.

Just checked, our panda is rev c3. Maybe you should hunt for differences
in the lowlevel startup code in TIs Xloader which I have not proted
correctly to barebox.

Sascha

> 
> I make panda_xload_defconfig compile and put to FAT SD card partition
> ranamed barebox.bin to u-boot.bin (MLO reads u-boot.bin by default).
> 
> Barebox start but after printing revision number is stuck. I add some
> printks and
> seems it hang in omap_hsmmc_probe funtion after mci_register(&hsmmc->mci) call.
> 
> I try with 2 SD cards and non of them is working.
> 
> Also try to load to flash partition only barebox.bin.itf + barebox.bin
> but this setup also
> doesn't work. AFAIU itf add some data before barebox to be possible to
> boot directly without
> x-loader. When run_shell is called barebox.bin should be copied do
> DDRAM and run.
> 
> Any ideas what should I check.
> 
> Thanks in advance,
> 
> marek
> 
> 
> -- 
> as simple and primitive as possible
> -------------------------------------------------
> Marek Belisko - OPEN-NANDRA
> Freelance Developer
> 
> Ruska Nova Ves 219 | Presov, 08005 Slovak Republic
> Tel: +421 915 052 184
> skype: marekwhite
> icq: 290551086
> web: http://open-nandra.com
> 
> _______________________________________________
> barebox mailing list
> barebox at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/barebox
> 

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |