testing barebox on calao sbc35-a9260 board
marek.belisko at gmail.com
Mon Jun 28 05:08:36 EDT 2010
On Mon, Jun 28, 2010 at 10:04 AM, Sascha Hauer <s.hauer at pengutronix.de> wrote:
> Hi Marek,
> On Fri, Jun 25, 2010 at 11:31:49AM +0200, Belisko Marek wrote:
>> I have a calao board sbc35-a9260 with u-boot pre-installed on it.
>> I would like to try barebox running on that board (also make some development).
>> I build at91sam9260ek_defconfig to try it out. I became to situation
>> that I don't know how to load image to board :)
>> I try via tftp but u-boot automatically try to boot it and I got some
>> error about magic number.
>> I think about possibility just download binary to some RAM address and
>> then use go command in u-boot
>> to test if barebox binary will work.
>> There exist some how-to or example how to do this?
> It's perfectly fine to start barebox from U-Boot with the 'go' command.
> Try 'setenv autostart no' in U-Boot to stop U-Boot from autostarting
I disable autostart and download barebox image to 0x8000 with
tftp 0x8000 barebox.bin and then jut go 0x8000 ended with:
## Starting application at 0x00008000 ...
Same I got when load latest compiled u-boot binary.
For compilation I used Codesourcery eabi toolchain arm-2009q3
Could I somehow check (without JTAG :)) if image is compiled OK
and could start on board?
> Pengutronix e.K. | |
> Industrial Linux Solutions | http://www.pengutronix.de/ |
> Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
> Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
as simple and primitive as possible
Marek Belisko - OPEN-NANDRA
Ruska Nova Ves 219 | Presov, 08005 Slovak Republic
Tel: +421 915 052 184
More information about the barebox