[PATCH 0/7] wifi: ath12k: Add monitor interface support on QCN9274

[Karthikeyan Periyasamy]

On 1/15/2025 11:25 PM, Nicolas Escande wrote:
> On Tue Jan 7, 2025 at 3:10 AM CET, Karthikeyan Periyasamy wrote:
>> Currently, monitor interface not supported. Therefore, add the missed TLV
>> tags parsing in the monitor parser, configure the monitor vdev state
>> identifier with HTT filter setup.
>>
>> Depends-On:
>> 	[PATCH v3 0/3] wifi: ath12k: Refactor monitor Rx handler
>> 	https://lore.kernel.org/all/20241224143613.164921-1-quic_periyasa@quicinc.com/
>>
>> 	[PATCH v2 00/14] wifi: ath12k: Enable monitor ring for updating station dump in QCN9274
>> 	https://lore.kernel.org/all/20241223060132.3506372-1-quic_ppranees@quicinc.com/
>>
>> 	[PATCH v2 00/10] wifi: ath12k: Add peer extended Rx statistics debugfs support
>> 	https://lore.kernel.org/all/20241224161442.263729-1-quic_periyasa@quicinc.com/
>>
>> Hari Chandrakanthan (1):
>>    wifi: ath12k: fix link valid field initialization in the monitor Rx
>>
>> Karthikeyan Periyasamy (1):
>>    wifi: ath12k: Replace band define G with GHZ where appropriate
>>
>> P Praneesh (5):
>>    wifi: ath12k: Add extra TLV tag parsing support in monitor Rx path
>>    wifi: ath12k: Avoid fetch Error bitmap and decap format from Rx TLV
>>    wifi: ath12k: change the status update in the monitor Rx
>>    wifi: ath12k: Avoid packet offset and FCS length from Rx TLV
>>    wifi: ath12k: add monitor interface support on QCN9274
>>
> [...]
> 
> Hello,
> 
> There might be something wrong with this series.
> 
> I applied it on top of ath-pending-202501150104 + the "ath12k: Add peer extended
> Rx statistics debugfs support" and now 'iw dev wlan0 station dump' shows me
> that the RSSI value seems to not be updated anymore after I stop a monitor
> interface on the same phy.
> 
> Steps to reproduce:
> iw phy phy0 interface add mon0 type monitor
> ip link set mon0 up
> # then just for 1 sec but it might not be usefull at all
> tcpdump -nepi mon0
> ip link set mon0 down
> watch -n1 iw dev wlan0 station dump
> # 'signal' seems to not be updating anymore, maybe some other fields too ?
> 

Not able to find the wlan0 interface details from the above steps ?


-- 
Karthikeyan Periyasamy
--
கார்த்திகேயன் பெரியசாமி