[PATCH 0/7] wifi: ath12k: Add monitor interface support on QCN9274

[Nicolas Escande]

On Tue Jan 7, 2025 at 3:10 AM CET, Karthikeyan Periyasamy wrote:
> Currently, monitor interface not supported. Therefore, add the missed TLV
> tags parsing in the monitor parser, configure the monitor vdev state
> identifier with HTT filter setup.
>
> Depends-On:
> 	[PATCH v3 0/3] wifi: ath12k: Refactor monitor Rx handler
> 	https://lore.kernel.org/all/20241224143613.164921-1-quic_periyasa@quicinc.com/
>
> 	[PATCH v2 00/14] wifi: ath12k: Enable monitor ring for updating station dump in QCN9274
> 	https://lore.kernel.org/all/20241223060132.3506372-1-quic_ppranees@quicinc.com/
>
> 	[PATCH v2 00/10] wifi: ath12k: Add peer extended Rx statistics debugfs support
> 	https://lore.kernel.org/all/20241224161442.263729-1-quic_periyasa@quicinc.com/
>
> Hari Chandrakanthan (1):
>   wifi: ath12k: fix link valid field initialization in the monitor Rx
>
> Karthikeyan Periyasamy (1):
>   wifi: ath12k: Replace band define G with GHZ where appropriate
>
> P Praneesh (5):
>   wifi: ath12k: Add extra TLV tag parsing support in monitor Rx path
>   wifi: ath12k: Avoid fetch Error bitmap and decap format from Rx TLV
>   wifi: ath12k: change the status update in the monitor Rx
>   wifi: ath12k: Avoid packet offset and FCS length from Rx TLV
>   wifi: ath12k: add monitor interface support on QCN9274
>
[...]

Hello,

There might be something wrong with this series.

I applied it on top of ath-pending-202501150104 + the "ath12k: Add peer extended
Rx statistics debugfs support" and now 'iw dev wlan0 station dump' shows me
that the RSSI value seems to not be updated anymore after I stop a monitor
interface on the same phy.

Steps to reproduce:
iw phy phy0 interface add mon0 type monitor
ip link set mon0 up
# then just for 1 sec but it might not be usefull at all
tcpdump -nepi mon0
ip link set mon0 down
watch -n1 iw dev wlan0 station dump
# 'signal' seems to not be updating anymore, maybe some other fields too ?

Don't know if this is from this series or something else broken before, but as
we could not add a monitor interface before, I could not see it.

There still is a possibility that I messed something up while applying it so I
would greatly appreciate if you could check it.

This is on split-phy QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1

Thanks