[PATCH v2 7/8] wifi: ath12k: refactor core start based on hardware group

Jeff Johnson quic_jjohnson at quicinc.com
Thu Apr 25 14:39:03 PDT 2024


On 4/24/2024 10:57 PM, Harshitha Prem wrote:
> From: Karthikeyan Periyasamy <quic_periyasa at quicinc.com>
> 
> Currently, mac allocate/register and core_pdev_create are initiated
> immediately when QMI firmware ready event is received for a particular
> device.
> 
> With hardware device group abstraction, QMI firmware ready event can be
> received simultaneously for different devices in the group and so, it
> should not be registered immediately rather it has to be deferred until
> all devices in the group has received QMI firmware ready.
> 
> To handle this, refactor the code of core start to move the following
> apis inside a wrapper ath12k_core_hw_group_start()
>         * ath12k_mac_allocate()
>         * ath12k_core_pdev_create()
>         * ath12k_core_rfkill_config()
>         * ath12k_mac_register()
>         * ath12k_hif_irq_enable()
> 
> similarly, move the corresponding destroy/unregister/disable apis
> inside wrapper ath12k_core_hw_group_stop()
> 
> Add the device flags to indicate pdev created and IRQ enabled which would
> be helpful for device clean up during failure cases.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> 
> Signed-off-by: Karthikeyan Periyasamy <quic_periyasa at quicinc.com>
> Co-developed-by: Harshitha Prem <quic_hprem at quicinc.com>
> Signed-off-by: Harshitha Prem <quic_hprem at quicinc.com>

Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3

Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>




More information about the ath12k mailing list