[PATCH 2/2] wifi: ath12k: set mlo_capable_flags based on QMI PHY capability

Jeff Johnson quic_jjohnson at quicinc.com
Mon Apr 22 07:42:41 PDT 2024


On 4/18/2024 5:56 AM, Raj Kumar Bhagat wrote:
> Currently, mlo_capable_flags is set to zero if dualmac device is
> detected based on One Time Programmable (OTP) register value.
> This is not generic and in future dualmac devices may support
> Single Link Operation (SLO) and Multi Link Operation (MLO).
> 
> Thus, set mlo_capable_flags based on 'single_chip_mlo_support'
> parameter from QMI PHY capability response message from the firmware.
> Also, add check on mlo_capable_flags to disable MLO parameter in the
> host capability QMI request message.
> 
> If the firmware does not respond with this optional parameter
> 'single_chip_mlo_support' in QMI PHY capability response, default
> ab->mlo_capable_flags is used.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.1.1-00209-QCAHKSWPL_SILICONZ-1

Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3

> 
> Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag at quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>



More information about the ath12k mailing list