[PATCH v8 12/12] wifi: ath11k: discard BSS_CHANGED_TXPOWER when EXT_TPC_REG_SUPPORT for 6 GHz

[Aditya Kumar Singh]

On 12/4/23 13:43, Baochen Qiang wrote:
> From: Wen Gong <quic_wgong at quicinc.com>
> 
> When station is connected to a 6 GHz AP, it has 2 ways to configure
> the power limit to firmware. The first way is to send 2 WMI commands
> WMI_PDEV_PARAM_TXPOWER_LIMIT2G/WMI_PDEV_PARAM_TXPOWER_LIMIT5G to
> firmware, the second way is to send WMI_VDEV_SET_TPC_POWER_CMDID to
> firmware which include more parameters for power control.
> 
> When firmware support SERVICE_EXT_TPC_REG, it means firmware support
> the second way for WMI_VDEV_SET_TPC_POWER_CMDID, then ath11k discard
> BSS_CHANGED_TXPOWER flag from mac80211 which is used to the first way
> for 6 GHz band and select the second way.
> 
> Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.23
> 
> Signed-off-by: Wen Gong <quic_wgong at quicinc.com>
> Signed-off-by: Baochen Qiang <quic_bqiang at quicinc.com>
> ---
...snip...
> @@ -3596,9 +3608,13 @@ static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
>   	if (changed & BSS_CHANGED_TXPOWER) {
>   		ath11k_dbg(ar->ab, ATH11K_DBG_MAC, "vdev_id %i txpower %d\n",
>   			   arvif->vdev_id, info->txpower);
> -
> -		arvif->txpower = info->txpower;
> -		ath11k_mac_txpower_recalc(ar);
> +		if (ath11k_mac_supports_station_tpc(ar, arvif, &info->chandef)) {
> +			ath11k_dbg(ar->ab, ATH11K_DBG_MAC,
> +				   "discard tx power, change to set TPC power\n");
> +		} else {
> +			arvif->txpower = info->txpower;
> +			ath11k_mac_txpower_recalc(ar);
> +		}

Could you check v6 once? I remember Wen told he would drop this check 
and let FW take the min value. If we do like this, then user could not 
set his own desired value even if that is well inside the reg limits.