[PATCH 4/6] dt-bindings: net: bluetooth: Document Qualcomm IPQ5018 Bluetooth controller

[Konrad Dybcio]

On 6/26/26 1:20 PM, George Moussalem wrote:
> On 6/26/26 14:53, Krzysztof Kozlowski wrote:
>> On Thu, Jun 25, 2026 at 06:10:08PM +0400, George Moussalem wrote:
>>> Document the Qualcomm IPQ5018 Bluetooth controller.
>>>
>>> Signed-off-by: George Moussalem <george.moussalem at outlook.com>
>>> ---

[...]

>>> +      compatible = "qcom,ipq5018-bt";
>>> +
>>> +      qcom,ipc = <&apcs_glb 8 23>;
>>> +      interrupts = <GIC_SPI 162 IRQ_TYPE_EDGE_RISING>;
>>
>> No firmware to load?
> 
> firmware is loaded by the remoteproc in patch 1
> 
>>
>> It feels like remoteproc node split is fake. The property qcom,rproc is
>> even more supporting that case. Shouldn't this be simply one device -
>> bluetooth? What sort of two devices do you have exactly? How can I
>> identify them in the hardware?
> 
> I wasn't sure how to represent the HW. Should I make this bluetooth node
> a childnode of the rproc? Essentially, this is the transport layer
> (using shared memory space and IPC/interrupt).
> 
> Most QCA BT controllers are also childnodes of a serdev/uart node as
> they use serdev for transport.
> 
> From what I understand, it's simply BT firmware running on this
> dedicated M0 core in the SoC itself connected to an RF.

Seems like this rhymes with the WPSS remoteproc +ATH1xK_AHB situation
- the Q6 core power sequences and manages the wireless controller,
while Linux gets to drive the device as it would if it were connected
over PCIe/ UART respectively, just with MMIO writes instead.

Konrad