[PATCH 3/5] wifi: ath10k: fix htt_q_state_conf & htt_q_state kernel-doc

[Randy Dunlap]

On 1/18/24 08:12, Jeff Johnson wrote:
> Currently kernel-doc reports:
> drivers/net/wireless/ath/ath10k/htt.h:1488: warning: cannot understand function prototype: 'struct htt_q_state_conf '
> drivers/net/wireless/ath/ath10k/htt.h:1542: warning: cannot understand function prototype: 'struct htt_q_state '
> 
> Update the kernel-doc for these two structs to resolve the warnings.
> 
> No functional changes, compile tested only.
> 
> Signed-off-by: Jeff Johnson <quic_jjohnson at quicinc.com>

Acked-by: Randy Dunlap <rdunlap at infradead.org>

> ---
>  drivers/net/wireless/ath/ath10k/htt.h | 10 +++++++---
>  1 file changed, 7 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/net/wireless/ath/ath10k/htt.h b/drivers/net/wireless/ath/ath10k/htt.h
> index 4a9270e2a4c8..eb0ce2f49315 100644
> --- a/drivers/net/wireless/ath/ath10k/htt.h
> +++ b/drivers/net/wireless/ath/ath10k/htt.h
> @@ -3,7 +3,7 @@
>   * Copyright (c) 2005-2011 Atheros Communications Inc.
>   * Copyright (c) 2011-2017 Qualcomm Atheros, Inc.
>   * Copyright (c) 2018, The Linux Foundation. All rights reserved.
> - * Copyright (c) 2021, 2023 Qualcomm Innovation Center, Inc. All rights reserved.
> + * Copyright (c) 2021, 2023-2024 Qualcomm Innovation Center, Inc. All rights reserved.
>   */
>  
>  #ifndef _HTT_H_
> @@ -1474,15 +1474,19 @@ enum htt_q_depth_type {
>  #define HTT_TX_Q_STATE_ENTRY_MULTIPLIER		0
>  
>  /**
> - * htt_q_state_conf - part of htt_frag_desc_bank_cfg for host q state config
> + * struct htt_q_state_conf - part of htt_frag_desc_bank_cfg for host q state config
>   *
>   * Defines host q state format and behavior. See htt_q_state.
>   *
> + * @paddr: Queue physical address
> + * @num_peers: Number of supported peers
> + * @num_tids: Number of supported TIDs
>   * @record_size: Defines the size of each host q entry in bytes. In practice
>   *	however firmware (at least 10.4.3-00191) ignores this host
>   *	configuration value and uses hardcoded value of 1.
>   * @record_multiplier: This is valid only when q depth type is MSDUs. It
>   *	defines the exponent for the power of 2 multiplication.
> + * @pad: struct padding for 32-bit alignment
>   */
>  struct htt_q_state_conf {
>  	__le32 paddr;
> @@ -1518,7 +1522,7 @@ struct htt_frag_desc_bank_cfg64 {
>  #define HTT_TX_Q_STATE_ENTRY_EXP_LSB		6
>  
>  /**
> - * htt_q_state - shared between host and firmware via DMA
> + * struct htt_q_state - shared between host and firmware via DMA
>   *
>   * This structure is used for the host to expose it's software queue state to

                                                    its
fwiw.

>   * firmware so that its rate control can schedule fetch requests for optimized
> 

-- 
#Randy