[PATCH 1/2] dt-bindings: net: wireless: ath10k: add qcom,no-msa-ready-indicator prop

[Marc Gonzalez]

On 28/02/2024 15:59, Jeff Johnson wrote:

> On 2/28/2024 5:24 AM, Marc Gonzalez wrote:
>
>> The driver waits for this indicator before proceeding,
>> yet some WCNSS firmwares apparently do not send it.
>> On those devices, it seems safe to ignore the indicator,
>> and continue loading the firmware.
> 
> Can you list the product/hardware/firmware where this is observed?
> Would prefer to fix the firmware if the issue is there

Hello Jeff,

Do you think it is possible that the ath10k IP block in the msm8998/sdm835
has never actually sent the MSA_READY indication?

Perhaps the vendor driver does not wait for MSA_READY, and therefore this
issue has never caused a problem downstream?

In that case, we could enable the work-around for all msm8998 boards?

Regards