[PATCH v3 1/2] dt-bindings: net: Convert ATH10K to YAML

[Konrad Dybcio]

On 6.04.2023 19:15, Krzysztof Kozlowski wrote:
> On 06/04/2023 14:55, Konrad Dybcio wrote:
>> Convert the ATH10K bindings to YAML.
>>
>> Dropped properties that are absent at the current state of mainline:
>> - qcom,msi_addr
>> - qcom,msi_base
>>
>> qcom,coexist-support and qcom,coexist-gpio-pin do very little and should
>> be reconsidered on the driver side, especially the latter one.
>>
>> Somewhat based on the ath11k bindings.
> 
> 
>> +  - reg
>> +
>> +additionalProperties: false
>> +
>> +allOf:
>> +  - if:
>> +      properties:
>> +        compatible:
>> +          contains:
>> +            enum:
>> +              - qcom,ipq4019-wifi
>> +    then:
>> +      properties:
>> +        interrupts:
>> +          minItems: 17
>> +          maxItems: 17
>> +
>> +        interrupt-names:
>> +          minItems: 17
> 
> Drop minItems (the number of items is defined by listing them below, as
> you did).
OK

> 
>> +          items:
>> +            - const: msi0
>> +            - const: msi1
>> +            - const: msi2
>> +            - const: msi3
>> +            - const: msi4
>> +            - const: msi5
>> +            - const: msi6
>> +            - const: msi7
>> +            - const: msi8
>> +            - const: msi9
>> +            - const: msi10
>> +            - const: msi11
>> +            - const: msi12
>> +            - const: msi13
>> +            - const: msi14
>> +            - const: msi15
>> +            - const: legacy
>> +
>> +        clocks:
>> +          items:
>> +            - description: Wi-Fi command clock
>> +            - description: Wi-Fi reference clock
>> +            - description: Wi-Fi RTC clock
>> +
>> +        clock-names:
>> +          items:
>> +            - const: wifi_wcss_cmd
>> +            - const: wifi_wcss_ref
>> +            - const: wifi_wcss_rtc
>> +
>> +      required:
>> +        - clocks
>> +        - clock-names
>> +        - interrupts
>> +        - interrupt-names
>> +        - resets
>> +        - reset-names
>> +
>> +  - if:
>> +      properties:
>> +        compatible:
>> +          contains:
>> +            enum:
>> +              - qcom,wcn3990-wifi
>> +
>> +    then:
>> +      properties:
>> +        clocks:
>> +          minItems: 1
>> +          items:
>> +            - description: XO reference clock
>> +            - description: Qualcomm Debug Subsystem clock
>> +
>> +        clock-names:
>> +          minItems: 1
>> +          items:
>> +            - const: cxo_ref_clk_pin
>> +            - const: qdss
>> +
>> +        interrupts:
>> +          items:
>> +            - description: CE0
>> +            - description: CE1
>> +            - description: CE2
>> +            - description: CE3
>> +            - description: CE4
>> +            - description: CE5
>> +            - description: CE6
>> +            - description: CE7
>> +            - description: CE8
>> +            - description: CE9
>> +            - description: CE10
>> +            - description: CE11
> 
> What about interrupt-names here? If they are not expected, then just
> interrupt-names: false
They obviously wouldn't hurt, but they're unused on the driver side:

for (i = 0; i < CE_COUNT; i++) {
		ret = platform_get_irq(ar_snoc->dev, i);

So I will forbid them.

Konrad
> 
> 
> 
> Best regards,
> Krzysztof
>