[PATCH v2 1/2] dt-bindings: net: Convert ATH10K to YAML

[Rob Herring]

On Thu, 06 Apr 2023 13:54:04 +0200, Konrad Dybcio wrote:
> Convert the ATH10K bindings to YAML.
> 
> Dropped properties that are absent at the current state of mainline:
> - qcom,msi_addr
> - qcom,msi_base
> 
> qcom,coexist-support and qcom,coexist-gpio-pin do very little and should
> be reconsidered on the driver side, especially the latter one.
> 
> Somewhat based on the ath11k bindings.
> 
> Signed-off-by: Konrad Dybcio <konrad.dybcio at linaro.org>
> ---
>  .../bindings/net/wireless/qcom,ath10k.txt          | 215 ------------
>  .../bindings/net/wireless/qcom,ath10k.yaml         | 359 +++++++++++++++++++++
>  2 files changed, 359 insertions(+), 215 deletions(-)
> 

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.example.dtb: wifi at 18800000: wifi-firmware: 'wifi-firmware' does not match any of the regexes: 'pinctrl-[0-9]+'
	From schema: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.example.dtb: wifi at 18800000: wifi-firmware: 'iommus' is a required property
	From schema: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.yaml

doc reference errors (make refcheckdocs):
MAINTAINERS: Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230406-topic-ath10k_bindings-v2-1-557f884a65d1@linaro.org

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.