[V2] ath10k-firmware: QCA9888 hw2.0: add GL.iNet GL-B2200 specific board file

[Enrico Mioso]

Hello all!!

I would like to add a board file for the PCI-E Wi-Fi interface present on the GL.iNet GL-B2200 mesh router, a device added a while ago to OpenWRt.

* Hardware description:

This device seems based on IPQ4019 / AP-DK04.1-C3.
Three radios are used:
- one QCA4019 radio is used for 2.4 GHZ operation (submitted on a previous message)
- one QCA4019 radio is used for 5 GHZ for operating on lower part of 5 GHZ spectrum (submitted on a previous message)
- a QCA9888V2 interface connected over PCI-E to operate on higher part of the 5 GHZ spectrum (contained in this message)

* origin of the board files:

The board file was provided by the manifacturer, who provided the original patch to support the device in OpenWRt.

* ids to be used with the board files

+ bus=pci,bmi-chip-id=0,bmi-board-id=16,variant=GL-B2200
SHA256: 7016cac25e5d35cf037f2f6aa63c03bd124fb521ec40c7843eb9d8424afa1a20

* attached files:

The names of the files are equal to the ID strings in the board-2.bin files, minus the .bin extension of course.

Kind regards,

Enrico
-------------- next part --------------
A non-text attachment was scrubbed...
Name: bus=pci,bmi-chip-id=0,bmi-board-id=16,variant=GL-B2200.bin
Type: application/octet-stream
Size: 12064 bytes
Desc: 
URL: <http://lists.infradead.org/pipermail/ath10k/attachments/20220502/fd5d9e5e/attachment-0001.bin>