[PATCH v2] dt-bindings: ath10k: fix qcom,coexist-support documentation

[Vincent Tremblay]

The driver is reading the value using the function
"of_property_read_u8", which is expecting the data to be
represented on 8 bits.

By default, the value specified in the DT is saved using a 32 bits
format, which cause the driver to read "0" instead of "1".

To make the driver work properly, the DT should specify the right
data representation to use.

Signed-off-by: Vincent Tremblay <vincent at vtremblay.dev>
---
v2 changes:
 - Remove unrelated changes

 .../devicetree/bindings/net/wireless/qcom,ath10k.txt        | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
index b61c2d5a0ff7..4a66ceeb1e76 100644
--- a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
+++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
@@ -92,8 +92,8 @@ Optional properties:
 - qcom,msa-fixed-perm: Boolean context flag to disable SCM call for statically
 		       mapped msa region.
 
-- qcom,coexist-support : should contain eithr "0" or "1" to indicate coex
-			 support by the hardware.
+- qcom,coexist-support : should contain a 8 bits value representing either
+			 "0" or "1" to indicate coex support by the hardware.
 - qcom,coexist-gpio-pin : gpio pin number  information to support coex
 			  which will be used by wifi firmware.
 
@@ -176,7 +176,7 @@ wifi0: wifi at a000000 {
 	qcom,msi_addr = <0x0b006040>;
 	qcom,msi_base = <0x40>;
 	qcom,ath10k-pre-calibration-data = [ 01 02 03 ... ];
-	qcom,coexist-support = <1>;
+	qcom,coexist-support = /bits/ 8 <1>;
 	qcom,coexist-gpio-pin = <0x33>;
 };
 
-- 
2.37.2