[PATCH v1 12/15] arm64: dts: qcom: qrb5165-rb5: add bluetooth support

[Dmitry Baryshkov]

Add support for the bluetooth part of the QCA6391 BT+WiFi chip present
on the RB5 board. WiFi is not supported yet, as it requires separate
handling of the PCIe device power.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
---
 arch/arm64/boot/dts/qcom/qrb5165-rb5.dts | 50 ++++++++++++++++++++++++
 1 file changed, 50 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
index 8ac96f8e79d4..326330f528fc 100644
--- a/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
+++ b/arch/arm64/boot/dts/qcom/qrb5165-rb5.dts
@@ -19,6 +19,7 @@ / {
 
 	aliases {
 		serial0 = &uart12;
+		serial1 = &uart6;
 		sdhc2 = &sdhc_2;
 	};
 
@@ -98,6 +99,25 @@ lt9611_3v3: lt9611-3v3 {
 		regulator-always-on;
 	};
 
+	qca_pwrseq: qca-pwrseq {
+		compatible = "qcom,qca6390-pwrseq";
+
+		#pwrseq-cells = <1>;
+
+		vddaon-supply = <&vreg_s6a_0p95>;
+		vddpmu-supply = <&vreg_s2f_0p95>;
+		vddrfa1-supply = <&vreg_s2f_0p95>;
+		vddrfa2-supply = <&vreg_s8c_1p3>;
+		vddrfa3-supply = <&vreg_s5a_1p9>;
+		vddpcie1-supply = <&vreg_s8c_1p3>;
+		vddpcie2-supply = <&vreg_s5a_1p9>;
+		vddio-supply = <&vreg_s4a_1p8>;
+
+		bt-enable-gpios = <&tlmm 21 GPIO_ACTIVE_HIGH>;
+		wifi-enable-gpios = <&tlmm 20 GPIO_ACTIVE_HIGH>;
+		swctrl-gpios = <&tlmm 124 GPIO_ACTIVE_HIGH>;
+	};
+
 	thermal-zones {
 		conn-thermal {
 			polling-delay-passive = <0>;
@@ -804,6 +824,26 @@ lt9611_rst_pin: lt9611-rst-pin {
 	};
 };
 
+&qup_uart6_default {
+	ctsrx {
+		pins = "gpio16", "gpio19";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
+	rts {
+		pins = "gpio17";
+		drive-strength = <2>;
+		bias-disable;
+	};
+
+	tx {
+		pins = "gpio18";
+		drive-strength = <2>;
+		bias-pull-up;
+	};
+};
+
 &qupv3_id_0 {
 	status = "okay";
 };
@@ -1193,6 +1233,16 @@ sdc2_card_det_n: sd-card-det-n {
 	};
 };
 
+&uart6 {
+	status = "okay";
+	bluetooth {
+		compatible = "qcom,qca6390-bt";
+		clocks = <&sleep_clk>;
+
+		bt-pwrseq = <&qca_pwrseq 1>;
+	};
+};
+
 &uart12 {
 	status = "okay";
 };
-- 
2.33.0