[PATCH 2/2] ath10k: Skip wait for delete response if firmware is down

[Ben Greear]

On 06/26/2020 11:11 AM, Rakesh Pillai wrote:
> Currently the driver waits for response from the
> firmware for all the delete cmds, eg: vdev_delete,
> peer delete. If the firmware is down, these wait
> will always timeout and return an error.
>
> Also during subsytems recovery, any attempt to
> send a WMI cmd to the FW will return the -ESHUTDOWN
> status, which when returned to mac80211, can cause
> unnecessary warnings to be printed on to the console,
> as shown below
>
> [ 2559.529565] Call trace:
> [ 2559.532214]  __sta_info_destroy_part2+0x160/0x168 [mac80211]
> [ 2559.538157]  __sta_info_flush+0x124/0x180 [mac80211]
> [ 2559.543402]  ieee80211_set_disassoc+0x130/0x2c0 [mac80211]
> [ 2559.549172]  ieee80211_mgd_deauth+0x238/0x25c [mac80211]
> [ 2559.554764]  ieee80211_deauth+0x24/0x30 [mac80211]
> [ 2559.559860]  cfg80211_mlme_deauth+0x258/0x2b0 [cfg80211]
> [ 2559.565446]  nl80211_deauthenticate+0xe4/0x110 [cfg80211]
> [ 2559.571064]  genl_rcv_msg+0x3a0/0x440
> [ 2559.574888]  netlink_rcv_skb+0xb4/0x11c
> [ 2559.578877]  genl_rcv+0x34/0x48
> [ 2559.582162]  netlink_unicast+0x14c/0x1e4
> [ 2559.586235]  netlink_sendmsg+0x2f0/0x360
> [ 2559.590317]  sock_sendmsg+0x44/0x5c
> [ 2559.593951]  ____sys_sendmsg+0x1c8/0x290
> [ 2559.598029]  ___sys_sendmsg+0xa8/0xfc
> [ 2559.601840]  __sys_sendmsg+0x8c/0xd0
> [ 2559.605572]  __arm64_compat_sys_sendmsg+0x2c/0x38
> [ 2559.610468]  el0_svc_common+0xa8/0x160
> [ 2559.614372]  el0_svc_compat_handler+0x2c/0x38
> [ 2559.618905]  el0_svc_compat+0x8/0x10
>
> Skip the wait for delete response from the
> firmware if the firmware is down. Also return
> success to the mac80211 calls when the peer delete
> cmd fails with return status -ESHUTDOWN.
>
> Tested-on: WCN3990 hw1.0 SNOC WLAN.HL.3.1-01040-QCAHLSWMTPLZ-1
>
> Signed-off-by: Rakesh Pillai <pillair at codeaurora.org>
> ---
>  drivers/net/wireless/ath/ath10k/mac.c | 18 ++++++++++++++----
>  1 file changed, 14 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
> index dc7befc..7ac6549 100644
> --- a/drivers/net/wireless/ath/ath10k/mac.c
> +++ b/drivers/net/wireless/ath/ath10k/mac.c
> @@ -701,7 +701,8 @@ static void ath10k_wait_for_peer_delete_done(struct ath10k *ar, u32 vdev_id,
>  	unsigned long time_left;
>  	int ret;
>
> -	if (test_bit(WMI_SERVICE_SYNC_DELETE_CMDS, ar->wmi.svc_map)) {
> +	if (test_bit(WMI_SERVICE_SYNC_DELETE_CMDS, ar->wmi.svc_map) &&
> +	    test_bit(ATH10K_FLAG_CRASH_FLUSH, &ar->dev_flags)) {

Don't you mean !test_bit(ATH10K_FLAG_CRASH_FLUSH, &ar->dev_flags))  ???

Or maybe I'm just mis-reading your patch?

Thanks,
Ben

-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com