[PATCH] ath10k: fix sending wmi cmd during the tdls teardown

[akolli at qti.qualcomm.com]

From: Anilkumar Kolli <akolli at codeaurora.org>

The current firmware 10.4-3.5.1-00035 on QCA9888 supports
TDLS explicit mode, it expects WMI_TDLS_ENABLE_PASSIVE
for tdls setup and WMI_TDLS_DISABLE for tdls teardown.

Signed-off-by: Anilkumar Kolli <akolli at qti.qualcomm.com>
---
 drivers/net/wireless/ath/ath10k/wmi.c |    3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c
index 38a97086708b..cad2e42dcef6 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.c
+++ b/drivers/net/wireless/ath/ath10k/wmi.c
@@ -7870,7 +7870,8 @@ static int ath10k_wmi_10_4_op_get_vdev_subtype(struct ath10k *ar,
 	if (!skb)
 		return ERR_PTR(-ENOMEM);
 
-	if (test_bit(WMI_SERVICE_TDLS_EXPLICIT_MODE_ONLY, ar->wmi.svc_map))
+	if (test_bit(WMI_SERVICE_TDLS_EXPLICIT_MODE_ONLY, ar->wmi.svc_map) &&
+	    state == WMI_TDLS_ENABLE_ACTIVE)
 		state = WMI_TDLS_ENABLE_PASSIVE;
 
 	if (test_bit(WMI_SERVICE_TDLS_UAPSD_BUFFER_STA, ar->wmi.svc_map))
-- 
1.7.9.5