[PATCH] Per chain RSSI reporting

[Michael Ney]

The submitted code also doesn't appear to handle RSSI per-peer which would be needed for any use when configured as an access point.

> On May 27, 2017, at 12:39 PM, Adrian Chadd <adrian at freebsd.org> wrote:
> 
> On 27 May 2017 at 09:07, Ben Greear <greearb at candelatech.com> wrote:
>> At low encoding rates, especially if it switches to a single-chain encoding,
>> maybe the on-air signal really is stronger?
>> 
>> Have you verified in some other manner than the signals reported by ath10k
>> are
>> wrong?
> 
> Hiya,
> 
> So yeah, multipath, higher TX rates == weaker TX signal, TPC, etc are
> all interesting to know about at the receiver. it's hard to separate
> that out from the noise sometimes, but in some controlled deployments
> its really obvious.
> 
> 
> 
> -adrian
> 
> _______________________________________________
> ath10k mailing list
> ath10k at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath10k