[PATCH] ath10k: Fix reported HT MCS rates with NSS > 1

[Sven Eckelmann]

On Donnerstag, 11. Mai 2017 11:39:46 CEST Arend Van Spriel wrote:
[...]
> So you leave VHT as is. Did you check with 11ac device? I am wondering
> if it needs the same change.

VHT MCS rates are reported by drivers with NSS + MCS rates 0-9 [1] as 
separated values. So I would say that the code is correct to report them as 
separate values. But no, I haven't tested with an 802.11ac capable device 
which I can fully trust because I didn't have one in arms reach (and I would 
have to compile a new firmware for it). But the output for a second ath10k 
based device looks ok'ish:

    Station ac:86:74:61:6b:30 (on wlan1)
            inactive time:  700 ms
            rx bytes:       10741
            rx packets:     95
            tx bytes:       9886
            tx packets:     86
            tx retries:     0
            tx failed:      0
            rx drop misc:   1
            signal:         -22 dBm
            signal avg:     -21 dBm
            tx bitrate:     780.0 MBit/s VHT-MCS 8 80MHz short GI VHT-NSS 2
            rx bitrate:     780.0 MBit/s VHT-MCS 8 80MHz short GI VHT-NSS 2
            rx duration:    8172 us
            authorized:     yes
            authenticated:  yes
            associated:     yes
            preamble:       long
            WMM/WME:        yes
            MFP:            no
            TDLS peer:      no
            DTIM period:    2
            beacon interval:100
            short slot time:yes
            connected time: 106 seconds

Kind regards,
	Sven

[1] http://mcsindex.com/
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 833 bytes
Desc: This is a digitally signed message part.
URL: <http://lists.infradead.org/pipermail/ath10k/attachments/20170511/3d173e6a/attachment.sig>