[v2, 1/3] ath10k: Use complete VHT chan width for 160MHz workaround

[Kalle Valo]

Sven Eckelmann <sven.eckelmann at openmesh.com> wrote:

> The ath10k firmware doesn't announce its VHT channel width capabilities in
> the vht_cap information from the "service ready event" arguments. The
> driver must therefore check whether the 160MHz short GI bit is set and
> whether the driver still doesn't set the bits for the 160/80+80 MHz
> capabilities.
> 
> The two bits for the channel width are a two bit integer and not two
> separate bits which cannot be parsed without the knowledge of the other
> bit. Using IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ (b10..) as a
> mask for this task doesn't make any sense. The correct mask for the VHT
> channel width should be used instead to make this check more readable.
> 
> Signed-off-by: Ben Greear <greearb at candelatech.com>
> [sven.eckelmann at openmesh.com: separate 160Mhz workaround cleanup, add commit
>  message]
> Signed-off-by: Sven Eckelmann <sven.eckelmann at openmesh.com>
> Signed-off-by: Kalle Valo <kvalo at qca.qualcomm.com>

3 patches applied to ath-next branch of ath.git, thanks.

e509e5947708 ath10k: use complete VHT chan width for 160MHz workaround
cc914a55006e ath10k: configure rxnss_override for QCA9984
6824834946a6 ath10k: set rxnss_override for QCA9888

-- 
https://patchwork.kernel.org/patch/9778085/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches