[RFC v3 08/11] ath10k: add QCA9377 usb hw_param item

[Kalle Valo]

Erik Stromdahl <erik.stromdahl at gmail.com> writes:

> Hardware parameters for QCA9377 usb devices.
>
> Signed-off-by: Erik Stromdahl <erik.stromdahl at gmail.com>

[...]

> --- a/drivers/net/wireless/ath/ath10k/core.c
> +++ b/drivers/net/wireless/ath/ath10k/core.c
> @@ -328,6 +328,29 @@ static const struct ath10k_hw_params ath10k_hw_params_list[] = {
>  		.vht160_mcs_rx_highest = 0,
>  		.vht160_mcs_tx_highest = 0,
>  	},
> +	{
> +		.id = QCA9377_HW_1_1_DEV_VERSION,
> +		.dev_id = QCA9377_1_0_DEVICE_ID,
> +		.name = "qca9377 hw1.1 usb",
> +		.patch_load_addr = QCA9377_HW_1_0_PATCH_LOAD_ADDR,
> +		.uart_pin = 6,
> +		.otp_exe_param = 0,
> +		.channel_counters_freq_hz = 88000,
> +		.max_probe_resp_desc_thres = 0,
> +		.cal_data_len = 8124,
> +		.fw = {
> +			.dir = QCA9377_HW_1_0_FW_DIR,
> +			.board = QCA9377_HW_1_0_BOARD_DATA_FILE_USB,
> +			.board_size = QCA9377_BOARD_DATA_SZ,
> +			.board_ext_size = QCA9377_BOARD_EXT_DATA_SZ,
> +		},
> +		.hw_ops = &qca988x_ops,
> +		.decap_align_bytes = 4,
> +		.max_num_peers = TARGET_QCA9377_HL_NUM_PEERS,
> +		.is_high_latency = true,
> +		.bus = ATH10K_BUS_USB,
> +		.start_once = true,
> +	},

Oh, forgot to mention that adding hw_params entry should be last in the
patchset and only added once all fixes etc are already in place (eg
patch 10 and 11 should be before this).

-- 
Kalle Valo