[v2, 1/2] dt: bindings: add new dt entry for ath10k calibration variant

[Kalle Valo]

Sven Eckelmann <sven.eckelmann at openmesh.com> wrote:

> The bus + bmi-chip-id + bmi-board-id is not enough to identify the correct
> board data file on QCA4019 based devices. Multiple different boards share
> the same values. Only the original reference designs can currently be
> identified and loaded from the board-2.bin. But these will not result in
> the correct calibration data when combined with the pre-calibration data
> from the device.
> 
> An additional "variant" information has to be provided (via SMBIOS or DT)
> to select the correct board data for a design which was modified by an ODM.
> 
> Signed-off-by: Sven Eckelmann <sven.eckelmann at openmesh.com>
> Signed-off-by: Kalle Valo <kvalo at qca.qualcomm.com>

2 patches applied to ath-next branch of ath.git, thanks.

40fb0eab30ba dt: bindings: add new dt entry for ath10k calibration variant
d06f26c5c8a4 ath10k: search DT for qcom,ath10k-calibration-variant

-- 
https://patchwork.kernel.org/patch/10102249/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches