[PATCH 2/2] ath10k: add per peer tx stats support for 10.2.4

[akolli at codeaurora.org]

Hello,

Thanks for verifying the patch.

On 2017-12-01 16:15, Maxime Bizon wrote:
> On Thu, 2017-11-30 at 18:28 +0530, akolli at qti.qualcomm.com wrote:
> 
> Hello,
> 
>> Tested on QCA9880 with firmware version 10.2.4.70.48. This should also
>> work with firmware branch 10.2.4-1.0-00029
> 
> I tried using your patch on 4.14 with firmware 10.2.4-1.0-00029
> 
I will test update.

>> Parse peer stats from pktlog packets and update the tx rate 
>> information
>> per STA. This way user space can query about transmit rate with iw:
> 
> everything works ok, ath10k_update_per_peer_tx_stats() is called and
> ath10k_sta fields are updated correctly
> 
> but tx bitrate is still 6 MBit/s in station dump
> 
Hope CONFIG_MAC80211_DEBUGFS is enabled in your build.
Please Run ping traffic and see and 'station dump'

>  # iw dev wlan1 station dump
> Station e4:42:a6:24:c8:95 (on wlan1)
> 	inactive time:	0 ms
> 	rx bytes:	222415
> 	rx packets:	1678
> 	tx bytes:	8511140
> 	tx packets:	5828
> 	tx retries:	0
> 	tx failed:	4
> 	rx drop misc:	2
> 	signal:  	-39 [-54, -56, -39] dBm
> 	signal avg:	-39 [-53, -55, -39] dBm
> 	tx bitrate:	6.0 MBit/s
> 	rx bitrate:	360.0 MBit/s VHT-MCS 8 40MHz short GI VHT-NSS 2
> 	authorized:	yes
> 	authenticated:	yes
> 	associated:	yes
> 	preamble:	long
> 	WMM/WME:	yes
> 	MFP:		no
> 	TDLS peer:	no
> 	DTIM period:	2
> 	beacon interval:96
> 	short slot time:yes
> 	connected time:	1136 seconds
> 
> I see that ath10k does not implement ->dump_station callback, so which
> part of the code updates the generic "struct station_info" fields ?
> 
> Am I missing a patch ?
> 
Rate parameters are updated from below call,
.sta_statistics                 = ath10k_sta_statistics,

Thanks,
Anil.