[PATCH 2/5] ath10k: add new htt definitions
Michal Kazior
michal.kazior at tieto.com
Wed Jan 13 06:01:05 PST 2016
These definitions are associated with some
improvements upcomming for 10.4 and QCA99X0.
Signed-off-by: Michal Kazior <michal.kazior at tieto.com>
---
drivers/net/wireless/ath/ath10k/htt.h | 153 +++++++++++++++++++++++++++++++++-
1 file changed, 150 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/ath/ath10k/htt.h b/drivers/net/wireless/ath/ath10k/htt.h
index edd3b9070de9..0c5628dafabf 100644
--- a/drivers/net/wireless/ath/ath10k/htt.h
+++ b/drivers/net/wireless/ath/ath10k/htt.h
@@ -52,6 +52,7 @@ enum htt_h2t_msg_type { /* host-to-target */
/* This command is used for sending management frames in HTT < 3.0.
* HTT >= 3.0 uses TX_FRM for everything. */
HTT_H2T_MSG_TYPE_MGMT_TX = 7,
+ HTT_H2T_MSG_TYPE_TX_FETCH_RESP = 11,
HTT_H2T_NUM_MSGS /* keep this last */
};
@@ -1306,9 +1307,43 @@ struct htt_frag_desc_bank_id {
* so we use a conservatively safe value for now */
#define HTT_FRAG_DESC_BANK_MAX 4
-#define HTT_FRAG_DESC_BANK_CFG_INFO_PDEV_ID_MASK 0x03
-#define HTT_FRAG_DESC_BANK_CFG_INFO_PDEV_ID_LSB 0
-#define HTT_FRAG_DESC_BANK_CFG_INFO_SWAP (1 << 2)
+#define HTT_FRAG_DESC_BANK_CFG_INFO_PDEV_ID_MASK 0x03
+#define HTT_FRAG_DESC_BANK_CFG_INFO_PDEV_ID_LSB 0
+#define HTT_FRAG_DESC_BANK_CFG_INFO_SWAP BIT(2)
+#define HTT_FRAG_DESC_BANK_CFG_INFO_Q_STATE_VALID BIT(3)
+#define HTT_FRAG_DESC_BANK_CFG_INFO_Q_STATE_DEPTH_TYPE_MASK BIT(4)
+#define HTT_FRAG_DESC_BANK_CFG_INFO_Q_STATE_DEPTH_TYPE_LSB 4
+
+enum htt_q_depth_type {
+ HTT_Q_DEPTH_TYPE_BYTES = 0,
+ HTT_Q_DEPTH_TYPE_MSDUS = 1,
+};
+
+#define HTT_TX_Q_STATE_NUM_PEERS (TARGET_10_4_NUM_QCACHE_PEERS_MAX + \
+ TARGET_10_4_NUM_VDEVS)
+#define HTT_TX_Q_STATE_NUM_TIDS 8
+#define HTT_TX_Q_STATE_ENTRY_SIZE 1
+#define HTT_TX_Q_STATE_ENTRY_MULTIPLIER 0
+
+/**
+ * htt_q_state_conf - part of htt_frag_desc_bank_cfg for host q state config
+ *
+ * Defines host q state format and behavior. See htt_q_state.
+ *
+ * @record_size: Defines the size of each host q entry in bytes. In practice
+ * however firmware (at least 10.4.3-00191) ignores this host
+ * configuration value and uses hardcoded value of 1.
+ * @record_multiplier: This is valid only when q depth type is MSDUs. It
+ * defines the exponent for the power of 2 multiplication.
+ */
+struct htt_q_state_conf {
+ __le32 paddr;
+ __le16 num_peers;
+ __le16 num_tids;
+ u8 record_size;
+ u8 record_multiplier;
+ u8 pad[2];
+} __packed;
struct htt_frag_desc_bank_cfg {
u8 info; /* HTT_FRAG_DESC_BANK_CFG_INFO_ */
@@ -1316,6 +1351,114 @@ struct htt_frag_desc_bank_cfg {
u8 desc_size;
__le32 bank_base_addrs[HTT_FRAG_DESC_BANK_MAX];
struct htt_frag_desc_bank_id bank_id[HTT_FRAG_DESC_BANK_MAX];
+ struct htt_q_state_conf q_state;
+} __packed;
+
+#define HTT_TX_Q_STATE_ENTRY_COEFFICIENT 128
+#define HTT_TX_Q_STATE_ENTRY_FACTOR_MASK 0x3f
+#define HTT_TX_Q_STATE_ENTRY_FACTOR_LSB 0
+#define HTT_TX_Q_STATE_ENTRY_EXP_MASK 0xc0
+#define HTT_TX_Q_STATE_ENTRY_EXP_LSB 6
+
+/**
+ * htt_q_state - shared between host and firmware via DMA
+ *
+ * This structure is used for the host to expose it's software queue state to
+ * firmware so that its rate control can schedule fetch requests for optimized
+ * performance. This is most notably used for MU-MIMO aggregation when multiple
+ * MU clients are connected.
+ *
+ * @count: Each element defines the host queue depth. When q depth type was
+ * configured as HTT_Q_DEPTH_TYPE_BYTES then each entry is defined as:
+ * FACTOR * 128 * 8^EXP (see HTT_TX_Q_STATE_ENTRY_FACTOR_MASK and
+ * HTT_TX_Q_STATE_ENTRY_EXP_MASK). When q depth type was configured as
+ * HTT_Q_DEPTH_TYPE_MSDUS the number of packets is scaled by 2 **
+ * record_multiplier (see htt_q_state_conf).
+ * @map: Used by firmware to quickly check which host queues are not empty. It
+ * is a bitmap simply saying.
+ * @seq: Used by firmware to quickly check if the host queues were updated
+ * since it last checked.
+ *
+ * FIXME: Is the q_state map[] size calculation really correct?
+ */
+struct htt_q_state {
+ u8 count[HTT_TX_Q_STATE_NUM_TIDS][HTT_TX_Q_STATE_NUM_PEERS];
+ u32 map[HTT_TX_Q_STATE_NUM_TIDS][(HTT_TX_Q_STATE_NUM_PEERS + 31) / 32];
+ __le32 seq;
+} __packed;
+
+#define HTT_TX_FETCH_RECORD_INFO_PEER_ID_MASK 0x0fff
+#define HTT_TX_FETCH_RECORD_INFO_PEER_ID_LSB 0
+#define HTT_TX_FETCH_RECORD_INFO_TID_MASK 0xf000
+#define HTT_TX_FETCH_RECORD_INFO_TID_LSB 12
+
+struct htt_tx_fetch_record {
+ __le16 info; /* HTT_TX_FETCH_IND_RECORD_INFO_ */
+ __le16 num_msdus;
+ __le32 num_bytes;
+} __packed;
+
+struct htt_tx_fetch_ind {
+ u8 pad0;
+ __le16 fetch_seq_num;
+ __le32 token;
+ __le16 num_resp_ids;
+ __le16 num_records;
+ struct htt_tx_fetch_record records[0];
+ __le32 resp_ids[0]; /* ath10k_htt_get_tx_fetch_ind_resp_ids() */
+} __packed;
+
+static inline void *
+ath10k_htt_get_tx_fetch_ind_resp_ids(struct htt_tx_fetch_ind *ind)
+{
+ return (void *)&ind->records[le16_to_cpu(ind->num_records)];
+}
+
+struct htt_tx_fetch_resp {
+ u8 pad0;
+ __le16 resp_id;
+ __le16 fetch_seq_num;
+ __le16 num_records;
+ __le32 token;
+ struct htt_tx_fetch_record records[0];
+} __packed;
+
+struct htt_tx_fetch_confirm {
+ u8 pad0;
+ __le16 num_resp_ids;
+ __le32 resp_ids[0];
+} __packed;
+
+enum htt_tx_mode_switch_mode {
+ HTT_TX_MODE_SWITCH_PUSH = 0,
+ HTT_TX_MODE_SWITCH_PUSH_PULL = 1,
+};
+
+#define HTT_TX_MODE_SWITCH_IND_INFO0_ENABLE BIT(0)
+#define HTT_TX_MODE_SWITCH_IND_INFO0_NUM_RECORDS_MASK 0xfffe
+#define HTT_TX_MODE_SWITCH_IND_INFO0_NUM_RECORDS_LSB 1
+
+#define HTT_TX_MODE_SWITCH_IND_INFO1_MODE_MASK 0x0003
+#define HTT_TX_MODE_SWITCH_IND_INFO1_MODE_LSB 0
+#define HTT_TX_MODE_SWITCH_IND_INFO1_THRESHOLD_MASK 0xfffc
+#define HTT_TX_MODE_SWITCH_IND_INFO1_THRESHOLD_LSB 2
+
+#define HTT_TX_MODE_SWITCH_RECORD_INFO0_PEER_ID_MASK 0x0fff
+#define HTT_TX_MODE_SWITCH_RECORD_INFO0_PEER_ID_LSB 0
+#define HTT_TX_MODE_SWITCH_RECORD_INFO0_TID_MASK 0xf000
+#define HTT_TX_MODE_SWITCH_RECORD_INFO0_TID_LSB 12
+
+struct htt_tx_mode_switch_record {
+ __le16 info0; /* HTT_TX_MODE_SWITCH_RECORD_INFO0_ */
+ __le16 num_max_msdus;
+} __packed;
+
+struct htt_tx_mode_switch_ind {
+ u8 pad0;
+ __le16 info0; /* HTT_TX_MODE_SWITCH_IND_INFO0_ */
+ __le16 info1; /* HTT_TX_MODE_SWITCH_IND_INFO1_ */
+ u8 pad1[2];
+ struct htt_tx_mode_switch_record records[0];
} __packed;
union htt_rx_pn_t {
@@ -1340,6 +1483,7 @@ struct htt_cmd {
struct htt_oob_sync_req oob_sync_req;
struct htt_aggr_conf aggr_conf;
struct htt_frag_desc_bank_cfg frag_desc_bank_cfg;
+ struct htt_tx_fetch_resp tx_fetch_resp;
};
} __packed;
@@ -1364,6 +1508,9 @@ struct htt_resp {
struct htt_rx_pn_ind rx_pn_ind;
struct htt_rx_offload_ind rx_offload_ind;
struct htt_rx_in_ord_ind rx_in_ord_ind;
+ struct htt_tx_fetch_ind tx_fetch_ind;
+ struct htt_tx_fetch_confirm tx_fetch_confirm;
+ struct htt_tx_mode_switch_ind tx_mode_switch_ind;
};
} __packed;
--
2.1.4
More information about the ath10k
mailing list