[PATCH 1/4] ath10k: remove supported chain mask

[Ben Greear]

On 02/25/2016 09:39 AM, Manoharan, Rajkumar wrote:
>>>>> Removing supported chainmask fields as it can be always derived
>>>>> from num_rf_chains.
>>>>>
>>>>> Signed-off-by: Rajkumar Manoharan <rmanohar at qti.qualcomm.com>
>>>>
>>> Hello,
>>>
>>> This one break monitor mode for qca988x and 10.x firmware:
>>> After Revert "ath10k: remove supported chain mask" - works correctly.
>>>
>> Janusz,
>>
>> Thanks for reporting. Will send out patch asap.
>>
>
> Janusz,
>
> It seems the change ("ath10k: remove supported chain mask") just exposed an
> hidden problem. The same target assert can be reproduced by below sequence
> even after reverting the commit.
>
> ifconfig wlan0 down
> iw wlan0 set type monitor
> iw phy0 set antenna 7
> ifconfig wlan0 up
>
> The actual cause of target assert is below commit.
>
> commit 5572a95b4b5768187652a346356e39e7542ca6e0
> Author: Ben Greear <greearb at candelatech.com>
> Date:   Mon Nov 24 16:22:10 2014 +0200
>
>      ath10k: apply chainmask settings to vdev on creation
>
> Configuring NSS vdev param on interface addition is causing the target assert in 10.1 firmware.
> Just creating monitor interface is causing assert with qca_main firmware.

Maybe change that patch so that it does not attempt to set nss just for monitor interfaces?

Thanks,
Ben

>
>
> -Rajkumar
>


-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com