[PATCH] ath10k: enable qca6174 hw3.2

[Michal Kazior]

On 29 January 2015 at 13:44, Kalle Valo <kvalo at qca.qualcomm.com> wrote:
> Michal Kazior <michal.kazior at tieto.com> writes:
>
>> The 3.2 revision has a different target BMI
>> version so it wasn't recognized by ath10k (despite
>> the chip_id rev being on the supported list
>> already).
>>
>> Signed-off-by: Michal Kazior <michal.kazior at tieto.com>
>
> But uses the same binaries as hw3.0?

Correct.


[...]
> I added this in pending branch to avoid people wondering why it uses 3.0
> binaries:
>
> diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
> index 36a8fcf349fa..310e12bc078a 100644
> --- a/drivers/net/wireless/ath/ath10k/core.c
> +++ b/drivers/net/wireless/ath/ath10k/core.c
> @@ -91,6 +91,7 @@ static const struct ath10k_hw_params ath10k_hw_params_list[] = {
>                 .patch_load_addr = QCA6174_HW_3_0_PATCH_LOAD_ADDR,
>                 .uart_pin = 6,
>                 .fw = {
> +                       /* uses same binaries as hw3.0 */

Good point. Thanks!


Michał