[PATCH] ath10k: Set SM power save disabled to default value

[Peter Oh]

Use SMPS disabled as default because FW does not indicate
any support of SMPS.

This change will help STAs out that don’t support SMPS from
sticking on 1SS, since they don’t have method to change it
back to multiple chains.

This change also should not affect power consumption of STAs
supporting SMPS, because they are capable to switch the mode
to dynamic or static either at the end of frame sequence or
by using SMPS action frame.

Signed-off-by: Peter Oh <poh at qca.qualcomm.com>
---
 drivers/net/wireless/ath/ath10k/mac.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index b4bdeb0..6146a29 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -3860,7 +3860,8 @@ static struct ieee80211_sta_ht_cap ath10k_get_ht_cap(struct ath10k *ar)
 	ht_cap.ampdu_density = IEEE80211_HT_MPDU_DENSITY_8;
 	ht_cap.cap |= IEEE80211_HT_CAP_SUP_WIDTH_20_40;
 	ht_cap.cap |= IEEE80211_HT_CAP_DSSSCCK40;
-	ht_cap.cap |= WLAN_HT_CAP_SM_PS_STATIC << IEEE80211_HT_CAP_SM_PS_SHIFT;
+	ht_cap.cap |=
+		WLAN_HT_CAP_SM_PS_DISABLED << IEEE80211_HT_CAP_SM_PS_SHIFT;
 
 	if (ar->ht_cap_info & WMI_HT_CAP_HT20_SGI)
 		ht_cap.cap |= IEEE80211_HT_CAP_SGI_20;
-- 
1.9.1