IBSS mode is now supported by CT firmware.

Yeoh Chun-Yeow yeohchunyeow at gmail.com
Wed Nov 26 17:04:59 PST 2014


On Thu, Nov 27, 2014 at 6:36 AM, Pushpal Sidhu <psidhu at gateworks.com> wrote:
> On Tue, Nov 25, 2014 at 4:59 PM, Ben Greear <greearb at candelatech.com> wrote:
>> I still cannot get WPA2 encryption to work, but open authentication
>> seems to work fine.  I still have a good bit more testing to do.
>> I cannot get ath9k to do encryption in IBSS mode either, so I
>> probably am mis-configuring something.
>
> I don't believe WPA2 is supported with adhoc (at least through
> wpa_supplicant). However, WPA should be and while testing your
> firmware, I found that it doesn't seem to work (They don't see each
> other and thus don't associate).
>
> I also found that, like the 999.x firmware, the rate's do not go
> higher than 54mbit/s. Is this due to the firmware not advertising
> proper rates or..?

Are you joining the adhoc network in non-HT mode? Anyway, even if you
use HT mode, the rate control is not working for 999.x firmware and
always stuck at 6Mbps as far as I know.

-----
Chun-Yeow



More information about the ath10k mailing list