[PATCH 1/2] ath10k: add modpram 'skip_otp' to ignore empty otp error during BMI

[Kalle Valo]

Rajkumar Manoharan <rmanohar at qti.qualcomm.com> writes:

> This patch would help bring up wifi interface with default board
> data in case of failures in otp download. It is useful for initial
> caliberation.
>
> Signed-off-by: Rajkumar Manoharan <rmanohar at qti.qualcomm.com>

[...]

> --- a/drivers/net/wireless/ath/ath10k/core.c
> +++ b/drivers/net/wireless/ath/ath10k/core.c
> @@ -31,12 +31,15 @@
>  unsigned int ath10k_debug_mask;
>  static bool uart_print;
>  static unsigned int ath10k_p2p;
> +static bool skip_otp;
>  module_param_named(debug_mask, ath10k_debug_mask, uint, 0644);
>  module_param(uart_print, bool, 0644);
>  module_param_named(p2p, ath10k_p2p, uint, 0644);
> +module_param(skip_otp, bool, 0644);
>  MODULE_PARM_DESC(debug_mask, "Debugging mask");
>  MODULE_PARM_DESC(uart_print, "Uart target debugging");
>  MODULE_PARM_DESC(p2p, "Enable ath10k P2P support");
> +MODULE_PARM_DESC(skip_otp, "Skip otp failure for calibration in testmode");

I added back the newlines:

--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -32,10 +32,12 @@ unsigned int ath10k_debug_mask;
 static bool uart_print;
 static unsigned int ath10k_p2p;
 static bool skip_otp;
+
 module_param_named(debug_mask, ath10k_debug_mask, uint, 0644);
 module_param(uart_print, bool, 0644);
 module_param_named(p2p, ath10k_p2p, uint, 0644);
 module_param(skip_otp, bool, 0644);
+
 MODULE_PARM_DESC(debug_mask, "Debugging mask");
 MODULE_PARM_DESC(uart_print, "Uart target debugging");
 MODULE_PARM_DESC(p2p, "Enable ath10k P2P support");

-- 
Kalle Valo