[PATCH 1/3] ath10k: Add debugging for tx-credits usage.

[Ben Greear]

On 03/25/2014 12:27 AM, Michal Kazior wrote:
> On 24 March 2014 17:50, Ben Greear <greearb at candelatech.com> wrote:
>> On 03/24/2014 04:21 AM, Michal Kazior wrote:
>>> On 24 March 2014 12:12, Kalle Valo <kvalo at qca.qualcomm.com> wrote:
>>
>>>>> -     status = ath10k_htc_send(htc, ATH10K_HTC_EP_0, skb);
>>>>> +     status = ath10k_htc_send(htc, ATH10K_HTC_EP_0, skb, __LINE__);
>>>>
>>>> Using line numbers in debug messages is very cumbersome. Some people
>>>> cherry pick patches, have their own changes and whatnot which will make
>>>> it more difficult to read the debug logs. Isn't there any better way to
>>>> do this?
>>>
>>> I would prefer to explicitly wait for tx credit replenishment in
>>> ath10k_wmi_cmd_send() after a command is sent instead of all these
>>> prints. This way you can get a full call trace if it times out.
>>
>> Would that be a performance problem (by effectively allowing only a single
>> item to be sent to the firmware at any given time?)
>
> The only thing that may suffer here is wmi mgmt tx but I wouldn't
> consider that performance critical.

In that case, why use credits at all?

Thanks,
Ben

>
>
> Michał
> --
> To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
> the body of a message to majordomo at vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>


-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com