[PATCH] ath10k: Fix getting stats from firmware.

[Yeoh Chun-Yeow]

Hi, Ben

I did a quick check again on STA mode. With or without your patch, the
printed peer stats are both identical but both wrong. See below:

             ath10k PEER stats
             =================

              Peer MAC address 00:00:00:00:00:00
                     Peer RSSI 256
                  Peer TX rate 0

              Peer MAC address 00:00:00:00:04:f0
                     Peer RSSI 17317
                  Peer TX rate 73

So I think that your patch makes no difference but do indeed providing
"correct" peer stats on latest AP firmware.

After applying the "ath10k: add the Rx rate in FW stats", I am able to
get the Tx and Rx Rate for all connected STAs to my AP.

---
Chun-Yeow

On Sat, Mar 22, 2014 at 12:12 AM, Kalle Valo <kvalo at qca.qualcomm.com> wrote:
> Ben Greear <greearb at candelatech.com> writes:
>
>> On 03/20/2014 11:41 PM, Yeoh Chun-Yeow wrote:
>>>>
>>>> Did you test 636 as well? 636 doesn't seem to support more than just `stats_id`.
>>>>
>>> Nope. Tested with 636 not working.
>>
>> Does the existing code work with 636?  If so, we can add two different cmd
>> structs and use the smaller one with 636, and the one I modified with
>> 10.x firmware?
>
> For this issue that would be the best approach. See Marek P's patch
> "ath10k: update regulatory domain settings for 10.x firmware" (not yet
> applied, still in ath-next-test branch) as an example how this can be
> done.
>
> --
> Kalle Valo