compat-wireless-2014-05-22 breaks ath10k in an Archer C7 v2

[Kalle Valo]

Michal Kazior <michal.kazior at tieto.com> writes:

> To recapitulate, can you please check what mac address your wlan interface has:
>
>  b) with otp failure ignored, try board.bin as extracted from the
> calibration mtd partition but firmware-2.bin as found in vanilla
> OpenWRT

I haven't checked this yet, but I assume that when the data from MTD is
used we should not even run otp.bin. It would be good to check that case
as well:

  b) don't run otp.bin at all, try board.bin as extracted from the
 calibration mtd partition but firmware-2.bin as found in vanilla
 OpenWRT

-- 
Kalle Valo