[PATCH v2 0/8] ath10k: Add thermal mitigation support

[Kalle Valo]

Kalle Valo <kvalo at qca.qualcomm.com> writes:

> The following patches add thermal sensor and thermal cooling device
> support in ath10k. For sensor, hwmon interface is used. For controlling
> temperature cooling device interface is used. For thermal mitigation,
> tx throttling is done using hw MAC quiet time setting.
>
> v2:
>
> * use ATH10K_FW_IE_WMI_OP_VERSION instead of a feature flag
>
> * add separate wmi mappings for 10.2.4
>
> * bump up FW API to 4
>
> * new patch: ath10k: set max_num_vdevs based on wmi op version
>
> * new patch: ath10k: use wmi op version to check which iface
>   combination to use
>
> * new patch: ath10k: print ath10k wmi op version
>
> ---
>
> Kalle Valo (3):
>       ath10k: set max_num_vdevs based on wmi op version
>       ath10k: use wmi op version to check which iface combination to use
>       ath10k: print ath10k wmi op version
>
> Rajkumar Manoharan (5):
>       ath10k: add 10.2.4 firmware support
>       ath10k: add wmi support for pdev_set_quiet_mode
>       ath10k: add thermal cooling device support
>       ath10k: add wmi interface for pdev_get_temperature
>       ath10k: add thermal sensor device support

All eight patches applied, thanks Rajkumar.

-- 
Kalle Valo