[PATCH] ath10k: allow dynamic bandwidth in hw rate control

[Kalle Valo]

Michal Kazior <michal.kazior at tieto.com> writes:

> Frames were never retransmitted with
> different/lower bandwidths, e.g. only 80MHz
> bandwidth was used when dealing with a VHT80
> peer.
>
> Allow HW rate control to try out different
> bandwidths when retransmitting. This increases
> robustness.
>
> Also, document the parameter properly.
>
> Signed-off-by: Michal Kazior <michal.kazior at tieto.com>

Thanks, applied.

-- 
Kalle Valo