Unable to receive beacon in IBSS mode
kvalo at qca.qualcomm.com
Fri Dec 20 05:17:07 EST 2013
Yeoh Chun-Yeow <yeohchunyeow at gmail.com> writes:
> I have observed if you create the interface in the ath10k as IBSS mode
> (WMI_VDEV_TYPE_IBSS). The ath10k_wmi_event_mgmt_rx is not able to
> receive the beacon frame. This maybe the reason when the STA up as
> adhoc mode not able to join the network.
> But if you put the ath10k as AP mode (WMI_VDEV_TYPE_AP), you are able
> to receive the beacon.
> Is this the correct behavior?
I haven't done any IBSS tests myself, but what firmware version are you
More information about the ath10k