[PATCH] wcn36xx: Set operational channel to 0 on disassociation
Bryan O'Donoghue
bryan.odonoghue at linaro.org
Thu Jul 30 07:09:47 EDT 2020
After a disassociated event we need to make sure we reset the operational
channel so that subsequent channel scans will not exclude the channel we
were using.
Doing a software scan on a wcn3680 showed that if we disassociated from an
AP we would never see it re-appear in a scan - unless we shifted the AP to
a different channel.
Setting the operational channel to zero on disassociation ensures that this
situation will not arise in the wild.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue at linaro.org>
---
drivers/net/wireless/ath/wcn36xx/main.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/net/wireless/ath/wcn36xx/main.c b/drivers/net/wireless/ath/wcn36xx/main.c
index fb8978a3c11e..4681d085b683 100644
--- a/drivers/net/wireless/ath/wcn36xx/main.c
+++ b/drivers/net/wireless/ath/wcn36xx/main.c
@@ -908,6 +908,7 @@ static void wcn36xx_bss_info_changed(struct ieee80211_hw *hw,
bss_conf->bssid,
vif->addr,
WCN36XX_HAL_LINK_IDLE_STATE);
+ wcn36xx_smd_switch_channel(wcn, vif, 0);
}
}
--
2.27.0
More information about the wcn36xx
mailing list