[PATCH 00/13] wcn36xx: ap mode debug 1

[Eugene Krasnikov]

Please rebase and send pull request.

2013/5/23 Kalle Valo <kvalo at qca.qualcomm.com>:
> I have been trying to get AP mode working on my mako. I can see beacons, but
> mako doesn't respond to probe requets from my test device (ath9k_htc). It
> doesn't even ack the frame.
>
> Here are few patches I have been working on while trying to debug that. I will
> rebase these patches once Pontus' patches have been applied.
>
> ---
>
> Kalle Valo (13):
>       smd: add debug message for hal start command
>       main: remove buggy else from wcn36xx_bss_info_changed()
>       main: remove unused mac80211 ops
>       main: don't lie about supported filters
>       Update probe response template
>       smd: add debug messages for sta and bss config responses
>       main: fix wcn36xx_bss_info_changed() to follow enable_beacon variable
>       smd: use real ssid on AP mode
>       smd: cleanup wcn36xx_smd_config_bss()
>       smd: organise wcn36xx_smd_config_bss() better
>       smd: set all parameters in config_bss()
>       smd: simplify update in config_bss()
>       Add IBSS support
>
>
>  hal.h     |    5 +
>  main.c    |  120 ++++++++++++--------------
>  smd.c     |  284 +++++++++++++++++++++++++++++++++++++++++++++++--------------
>  smd.h     |    4 +
>  wcn36xx.h |    2
>  5 files changed, 280 insertions(+), 135 deletions(-)
>
>
> _______________________________________________
> wcn36xx mailing list
> wcn36xx at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/wcn36xx



-- 
Best regards,
Eugene