[PATCH 2/2] Simplify scanning and use correct receive channel
Kalle Valo
kvalo at qca.qualcomm.com
Wed May 22 03:03:54 EDT 2013
Olof Johansson <dev at skyshaper.net> writes:
> This simplifies the scanning a bit by removing the end_scan which is
> not necessary. It also makes use of the channel switch command instead
> of using start scan on every channel.
>
> Reorders the 2.4Ghz channels to that the hw_values are correct
> and possible to use.
Looks good to me. Though your patches are whitespace damaged so it was a bit
difficult to review. I assume it was just a problem with sending the patches.
--
Kalle Valo
More information about the wcn36xx
mailing list