[PATCH] ramips: overwrite reset gpio properties in DIR-860L DTS
Chuanhong Guo
gch981213 at gmail.com
Sat Feb 13 05:23:28 EST 2021
Hi!
On Sat, Feb 13, 2021 at 5:55 PM Stijn Segers <foss at volatilesystems.org> wrote:
>
> As suggested by Sergio, this adds GPIOs 19 and 8 explicitly into the
> DIR-860L DTS, so the PCI-E ports get reset and the N radio (radio1)
> on PCI-E port 1 comes up reliably.
>
> Fixes the following error that popped up in dmesg:
>
> [ 1.638942] mt7621-pci 1e140000.pcie: pcie1 no card, disable it (RST & CLK)
>
> Suggested-by: Sergio Paracuellos <sergio.paracuellos at gmail.com>
> Signed-off-by: Stijn Segers <foss at volatilesystems.org>
> ---
> target/linux/ramips/dts/mt7621_dlink_dir-860l-b1.dts | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/target/linux/ramips/dts/mt7621_dlink_dir-860l-b1.dts b/target/linux/ramips/dts/mt7621_dlink_dir-860l-b1.dts
> index 5d1c336736..65d53e4ef4 100644
> --- a/target/linux/ramips/dts/mt7621_dlink_dir-860l-b1.dts
> +++ b/target/linux/ramips/dts/mt7621_dlink_dir-860l-b1.dts
> @@ -142,6 +142,12 @@
> };
>
> &pcie {
> + pinctrl-names = "default";
pinctrl-names is already "default" in mt7621.dtsi.
> + pinctrl-0 = <&pcie_pins>;
pinctrl-0 is already pcie_pins in mt7621.dtsi as well.
I'm fine with just dropping these two lines due to the fact that
we mainly used state_default to set up pinctrl in ramips.
(Ideally a separated pinctrl node with uart3 as gpio should be
defined and referenced here.)
> +
> + reset-gpios = <&gpio 19 GPIO_ACTIVE_LOW>,
> + <&gpio 8 GPIO_ACTIVE_LOW>;
> +
> status = "okay";
> };
>
--
Regards,
Chuanhong Guo
More information about the openwrt-devel
mailing list