[OpenWrt-Devel] [PATCH] ramips: convert TP-Link MT7620 boards to tpt trigger

David Bauer mail at david-bauer.net
Thu Jan 2 12:50:47 EST 2020


Hello Adrian,

On 1/2/20 4:25 PM, mail at adrianschmutzler.de wrote:
> while I appreciate your patch, the choice of phy0tpt vs. phy1tpt looks strange to me for several devices. E.g. for C20i you are converting a phy0radio to a phy1tpt. Is this a mistake or a misunderstanding from my side?

This is due to a previously false trigger assignment. The device only has 1 WiFi LED.
OpenWrt in this case maps the LED to the 2.4 GHz radio. phy0 however is the MT7610 chip
(which is probed prior to rt2x00), so this is wrong for the device. This most likely
happened, as the board was introduced without support for the M7610. When the MT7610
was introduced later, the LED trigger was not changed (as the 2.4GHz radio became phy1).

I will add a note to the commit message, a separate patch for this change however is
superfluous.

Best wishes
David

_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel



More information about the openwrt-devel mailing list