[OpenWrt-Devel] [PATCH 3/3] ath79: add support for Netgear WNDR4500 v3

Michal Cieslakiewicz michal.cieslakiewicz at wp.pl
Sat Dec 21 08:55:55 EST 2019


This patch introduces support for Netgear WNDR4500v3. Router
is very similar to WNDR4300v2 and is based on the same PCB.

Information gathered from various Internet sources (including
https://patchwork.ozlabs.org/patch/809227/) shows following
differences to WNDR4300v2:

 * two USB 2.0 ports
 * WPS and RFKILL buttons soldered to secondary pads
 * described as N900 device with 3x3:3 MIMO for 2.4GHz radio
 * power supply requirement is DC 12V 2.5A
 * HW ID suffix differs in one digit
 * bigger case

Signed-off-by: Michal Cieslakiewicz <michal.cieslakiewicz at wp.pl>
---
 package/boot/uboot-envtools/files/ath79       |  1 +
 .../ath79/dts/qca9563_netgear_wndr4500-v3.dts | 41 +++++++++++++++++++
 target/linux/ath79/image/nand.mk              | 11 +++++
 .../ath79/nand/base-files/etc/board.d/01_leds |  3 +-
 .../nand/base-files/etc/board.d/02_network    |  6 ++-
 .../etc/hotplug.d/firmware/10-ath9k-eeprom    |  6 ++-
 6 files changed, 63 insertions(+), 5 deletions(-)
 create mode 100644 target/linux/ath79/dts/qca9563_netgear_wndr4500-v3.dts

diff --git a/package/boot/uboot-envtools/files/ath79 b/package/boot/uboot-envtools/files/ath79
index 85a0342a60..aafced98db 100644
--- a/package/boot/uboot-envtools/files/ath79
+++ b/package/boot/uboot-envtools/files/ath79
@@ -27,6 +27,7 @@ librerouter,librerouter-v1|\
 netgear,ex6400|\
 netgear,ex7300|\
 netgear,wndr4300-v2|\
+netgear,wndr4500-v3|\
 netgear,wnr1000-v2|\
 netgear,wnr2000-v3|\
 netgear,wnr2200-8m|\
diff --git a/target/linux/ath79/dts/qca9563_netgear_wndr4500-v3.dts b/target/linux/ath79/dts/qca9563_netgear_wndr4500-v3.dts
new file mode 100644
index 0000000000..95e30ea84b
--- /dev/null
+++ b/target/linux/ath79/dts/qca9563_netgear_wndr4500-v3.dts
@@ -0,0 +1,41 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+/dts-v1/;
+
+#include "qca9563_netgear_wndr.dtsi"
+
+/ {
+	compatible = "netgear,wndr4500-v3", "qca,qca9563";
+	model = "Netgear WNDR4500 v3";
+};
+
+&leds {
+	usb1_green {
+		label = "netgear:green:usb1";
+		gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
+		trigger-sources = <&hub_port0>;
+		linux,default-trigger = "usbport";
+	};
+
+	usb2_green {
+		label = "netgear:green:usb2";
+		gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
+		trigger-sources = <&hub_port1>;
+		linux,default-trigger = "usbport";
+	};
+};
+
+&usb_phy1 {
+	status = "okay";
+};
+
+&usb1 {
+	#address-cells = <1>;
+	#size-cells = <0>;
+	status = "okay";
+
+	hub_port1: port at 1 {
+		reg = <1>;
+		#trigger-source-cells = <0>;
+	};
+};
diff --git a/target/linux/ath79/image/nand.mk b/target/linux/ath79/image/nand.mk
index a81127a962..529ae870a5 100644
--- a/target/linux/ath79/image/nand.mk
+++ b/target/linux/ath79/image/nand.mk
@@ -162,6 +162,17 @@ define Device/netgear_wndr4300-v2
 endef
 TARGET_DEVICES += netgear_wndr4300-v2
 
+define Device/netgear_wndr4500-v3
+  SOC := qca9563
+  DEVICE_MODEL := WNDR4500
+  DEVICE_VARIANT := v3
+  NETGEAR_KERNEL_MAGIC := 0x27051956
+  NETGEAR_BOARD_ID := WNDR4500series
+  NETGEAR_HW_ID := 29764821+2+128+128+3x3+3x3+5508012173
+  $(Device/netgear_ath79_nand)
+endef
+TARGET_DEVICES += netgear_wndr4500-v3
+
 define Device/zyxel_nbg6716
   SOC := qca9558
   DEVICE_VENDOR := ZyXEL
diff --git a/target/linux/ath79/nand/base-files/etc/board.d/01_leds b/target/linux/ath79/nand/base-files/etc/board.d/01_leds
index 0376b7cfc6..d9989ec538 100755
--- a/target/linux/ath79/nand/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/nand/base-files/etc/board.d/01_leds
@@ -14,7 +14,8 @@ glinet,gl-ar300m-nor)
 	;;
 netgear,wndr3700-v4|\
 netgear,wndr4300|\
-netgear,wndr4300-v2)
+netgear,wndr4300-v2|\
+netgear,wndr4500-v3)
 	ucidef_set_led_switch "wan-amber" "WAN (amber)" "netgear:amber:wan" "switch0" "0x20"
 	;;
 esac
diff --git a/target/linux/ath79/nand/base-files/etc/board.d/02_network b/target/linux/ath79/nand/base-files/etc/board.d/02_network
index 135a06d44b..bd02a4b383 100755
--- a/target/linux/ath79/nand/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/nand/base-files/etc/board.d/02_network
@@ -18,7 +18,8 @@ ath79_setup_interfaces()
 		;;
 	netgear,wndr3700-v4|\
 	netgear,wndr4300|\
-	netgear,wndr4300-v2)
+	netgear,wndr4300-v2|\
+	netgear,wndr4500-v3)
 		ucidef_add_switch "switch0" \
 			"0 at eth0" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "5:wan"
 		;;
@@ -39,7 +40,8 @@ ath79_setup_macs()
 	case "$board" in
 	netgear,wndr3700-v4|\
 	netgear,wndr4300|\
-	netgear,wndr4300-v2)
+	netgear,wndr4300-v2|\
+	netgear,wndr4500-v3)
 		wan_mac=$(mtd_get_mac_binary caldata 0x6)
 		;;
 	zyxel,nbg6716)
diff --git a/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
index 7ee291d109..d2f8bae1ca 100644
--- a/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
+++ b/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
@@ -11,7 +11,8 @@ case "$FIRMWARE" in
 	case $board in
 	netgear,wndr3700-v4|\
 	netgear,wndr4300|\
-	netgear,wndr4300-v2)
+	netgear,wndr4300-v2|\
+	netgear,wndr4500-v3)
 		caldata_extract "caldata" 0x1000 0x440
 		;;
 	zyxel,nbg6716)
@@ -27,7 +28,8 @@ case "$FIRMWARE" in
 	case $board in
 	netgear,wndr3700-v4|\
 	netgear,wndr4300|\
-	netgear,wndr4300-v2)
+	netgear,wndr4300-v2|\
+	netgear,wndr4500-v3)
 		caldata_extract "caldata" 0x5000 0x440
 		;;
 	*)
-- 
2.24.1


_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel



More information about the openwrt-devel mailing list